Announcement

Collapse
No announcement yet.

Poly bushing squeak

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Poly bushing squeak

    First cold snap, now I know what everyone is saying about they squeak. Previous owner did install zerk fittings. What do I grease them with? Car feels super tight, but I dont know if I would have poly installed if I had a choice.

  • #2
    SuperLube is what I use in mine. You don't want to use any grease that's petroleum based that'll attack the poly. You can snag a tube of it that'll fit into a grease gun - I use this mini-grease setup just cuz. https://www.amazon.com/Super-Lube-21...RFN0Y2XH1AYJSM

    Comment


    • #3
      I use Super lube in a grease gun. You can get it on Amazon.

      Super Lube 41150 Synthetic Grease (NLGI 2), 14.1 oz Cartridge https://www.amazon.com/dp/B0042FG74W/ref=cm_sw_r_cp_apa_woO9zbKK0VCMY
      '00 Silver Miata

      Comment


      • #4
        Haha! Got distracted while posting. ����
        '00 Silver Miata

        Comment


        • #5
          Thanks guys. So you had the same problem when it got cold? Also when I let the car off the jackstands, it stays raised up until I drive it, and the suspension settles back down. Normal,correct?

          Comment


          • #6
            The easiest and best solution is to buy Sadfab's bronze sleeves for the poly bushings. They act as a bearing to remove the stiction caused by the grease getting washed out.
            '00 Silver Miata

            Comment

            Working...
            X