LINK ECU, MP62 Supercharger, 1.8L Engine

[Marty]

'94-95 1.8L LINK ECU:

In perfect working order, ready to go into your car! Will work with '96-'97 if you re-wire your harness to OBDI.

Includes:

* LINK ECU with newest software in Mazda ECU case
* LINK MAP Sensor
* LINK Keypad
* Intake Air Temp Sensor
* Knock Sensor
* Serial LINK Connector for Laptops

$600 Shipped

Magnuson BRP MP62 Supercharger Kit for 94+ cars:

Freshly rebuilt from Magnuson, only 20miles on it. Just about everything was replaced. New rotor group, new bearings, new actuator, etc, etc,etc, etc. BRP Head bracket only has 20miles as well. This is the newer, 6-Rib setup with the auto-tensioner and BTB.

You get:

* MP62 Unit
* All brackets and power steering bracket
* Auto Tensioner
* Edelbrock 70mm Throttle Body
* Intake with K&N Filter
* Dummy Throttle Body
* Stock Mazda TPS
* 6 rib pulleys good for 10psi
* All hardware

You will need:

* Intercooler or crossover pipe. I can include a Monsterflow crossover if needed.

http://martymartymarty.net/Marty/4Sale/supercharger1.jpg
http://martymartymarty.net/Marty/4Sale/supercharger2.jpg

$1700 plus shipping *due to weight*

1.8L Engine

It's a '99 block, '99 crank, '99 rods' 01 pistons (higher compression), with a '96 head. The block was decked .003 and the head was just cleaned and planed.. The head has '96 cams, and '99 solid lifters. It has all Clevite bearings and only about 20miles on it. Long block, with intake manifold, coil pack, alternator, and stock injectors.

$800



Thanks!

[Jack-MX5ATLanta.com]

:jawdrop: Too much stuff here I want. God this would screw me financially for a while but... :jawdrop:

[RotorNutFD3S]

Marty, can you keep a/c with the s/c setup?

[Marty]

yep



Please correct the following errors before continuing:

* The message is too short. Please enter a longer message

[RotorNutFD3S]

:lol: at the way you made the message longer.

I'm PM'ing you.

[nickt93]

Marty - would you be willing to sell the Seriallink connector separately? I've been looking for one for the past few weeks unsuccessfully and would love to get my hands on yours! Since it is an add on accessory for the Link anyway, you'll still be able to sell as a full Link setup. Help a fellow MX5Atlanta'r out! $50?

[GraffitiPanda]

How many miles on the motor?

[wildfire0310]

How many miles on the motor?

The head has '96 cams, and '99 solid lifters. It has all Clevite bearings and only about 20miles on it.


Thanks!


read